USDCAD Technical Analysis – Pullback or reversal?

<p>USD</p><ul><li>The Fed <a href="https://www.forexlive.com/news/fomc-decision-no-change-to-rates-2024-median-dot-46-vs-49-expected-20231213/">left interest rates unchanged</a> as expected at the last meeting with a shift in
the statement that indicated the end of the tightening cycle. </li><li>The Summary of Economic Projections showed a
downward revision to Growth and Core PCE in 2024 while the Unemployment Rate
was left unchanged. Moreover, the Dot Plot was revised to show three rate cuts
in 2024 compared to just two in the last projection. </li><li><a href="https://www.forexlive.com/centralbank/powell-qa-noted-that-officials-talked-about-path-for-cuts-today-20231213/">Fed Chair Powell</a> didn't push back against the strong dovish pricing
and even said that they are focused on not making the mistake of holding rates
high for too long.</li><li>The latest <a href="https://www.forexlive.com/news/us-november-pce-core-inflation-32-vs-33-expected-20231222/">US PCE</a> missed expectations across the board with
the Core 6-month annualised rate falling below the Fed’s target at 1.9%. </li><li>The labour market has been softening via less job
opportunities rather than more layoffs with the <a href="https://www.forexlive.com/news/us-initial-jobless-claims-218k-vs-210k-estimate-20231228/">Initial Claims</a> hovering around cycle lows and Continuing Claims
remaining high. </li><li>The latest <a href="https://www.forexlive.com/news/us-november-ism-manufacturing-pmi-467-vs-476-expected-20231201/">ISM Manufacturing PMI</a> missed expectations falling further into
contraction, while the <a href="https://www.forexlive.com/news/us-november-ism-services-527-vs-520-expected-20231205/">ISM Services PMI</a> beat forecasts holding on in expansion. </li><li>The market expects the Fed to start cutting rates
in Q1 2024.</li></ul><p>CAD</p><ul><li>The BoC <a href="https://www.forexlive.com/centralbank/bank-of-canada-holds-rates-at-500-as-expected-20231206/">kept the interest rate steady at
5.00%</a> as expected at the last meeting with
the usual caveat that it’s prepared to raise the policy rate further if needed.</li><li>BoC <a href="https://www.forexlive.com/centralbank/bank-of-canada-governor-macklem-tips-rate-cuts-in-2024-but-timing-remains-uncertain-20231219/">Governor Macklem</a> recently has been leaning on a more
neutral side and even started to talk about rate cuts although he remains
uncertain on the timing. </li><li>The latest <a href="https://www.forexlive.com/news/canada-cpi-inflation-for-november-yoy-31-versus-29-estimate-20231219/">Canadian CPI</a> beat expectations across the board with
the underlying inflation measures remaining elevated, which should give the BoC
a reason to wait for more data before considering rate cuts. </li><li>On the <a href="https://www.forexlive.com/news/canada-november-employment-249k-vs-150k-expected-20231201/">labour market</a> side, the latest report beat expectations
although the unemployment rate ticked higher again. </li><li>The Canadian PMIs continue to fall
further into contraction as the economy keeps on weakening amid restrictive
monetary policy. </li><li>The market expects the BoC to start
cutting rates in Q2 2024.</li></ul><p>USDCAD Technical Analysis –
Daily Timeframe</p><p>On the daily chart, we can see that USDCAD bounced
on the 1.32 handle and started to correct higher after an aggressive selloff in
the past few weeks. We can see that we have a good <a href="https://www.forexlive.com/Education/technical-analysis-support-and-resistance-20220405/">resistance</a> zone
around the 1.3382 level where we can also find the <a href="https://www.forexlive.com/Education/technical-analysis-confluence-20220318/">confluence</a> with the
50% <a href="https://www.forexlive.com/Education/technical-analysis-using-fibonacci-retracements-20220421/">Fibonacci retracement</a> level
and the red 21 <a href="https://www.forexlive.com/Education/technical-analysis-understanding-moving-averages-20220425/">moving average</a>. This is
where we can expect the sellers to step in again to target a new low.</p><p>USDCAD Technical Analysis –
4 hour Timeframe</p><p>On the 4 hour chart, we can see that the latest leg
lower <a href="https://www.forexlive.com/Education/technical-analysis-understanding-divergence-20220429/">diverged</a> with the
<a href="https://www.forexlive.com/Education/technical-analysis-understanding-macd-20220427/">MACD</a> which is
generally a sign of weakening momentum often followed by pullbacks or
reversals. In this case, the target for the pullback should come right around
the resistance zone where we can expect the sellers to start piling in. If the
price breaks above the resistance zone, the bearish setup would be invalidated,
and the buyers will likely increase the bullish bets to start targeting the
1.36 handle. </p><p>USDCAD Technical
Analysis – 1 hour Timeframe</p><p>On the 1 hour chart, we can see that from
a risk management perspective, late buyers might want to wait for a pullback
into the 1.3270 level where we can find the confluence of the recent swing
high, the 50% Fibonacci retracement level and the 4-hour 21 moving average. </p><p>Upcoming Events</p><p><a href="https://www.forexlive.com/EconomicCalendar">This week</a> is full of key economic data which will
culminate with the NFP report on Friday. We begin today with the US ISM
Manufacturing PMI and Job Openings and given the recent trends there could be
room for disappointment. Later in the day, we will get the release of the FOMC
Minutes, but it’s not expected to be market-moving given that it’s three weeks
old data. Tomorrow, we will have another slate of US labour market data with
the release of the US ADP and Jobless Claims figures. Finally, on Friday, we
conclude the week with the Canadian Jobs data, the NFP report and the ISM
Services PMI. </p>

This article was written by FL Contributors at www.forexlive.com.